This article covers how to manually go through the FOMOD process because the FOMOD installation is not working properly. For how to install the mod, check out our other post.
1. Unzip.
2.
three folders 01,02,03 with the numbers xx-xx.
ESP(folder), and the Main folder.
3.
Select either (01-00) or (01-01).
Drag and drop the Meshes folder inside that folder into the Main folder.
If you receive a warning message, click (All Yes).
There are 3 steps, 01 through 03. Choose only one for each step.
01-xx [meshes]/ 00 Enable the Slash effect. | 01 Disable.
02-xx [meshes]/ 00 Use the DI unique spark. | 01 Use Vanilla Spark. Select this option if you want to use a different spark mod.
03-xx [Textures]/ 01~06 Choose a slash color. All colors and glow intensities are strongly affected by ENB.
Repeat the method.
03-00 Dark is special.
You must install 03-00 after installing 01-00 for it to work, and skip 03-01~06.
4.
The next step is to install compatible plugins. If you are not using Enhanced Blood Texture, or Immersive Sounds - Compendium, skip this step.
Inside the ESP folder, there are 5 ESP files.
Dynamic Impact - Slash Effects X-01EBT \ Enhanced Blood Texture
Dynamic Impact - Slash Effects X-01EBTLite \ Enhanced Blood Texture Lite
Dynamic Impact - Slash Effects X-02ISC \ Immersive Sounds - Compendium
Dynamic Impact - Slash Effects X-03EBT_ISC \ Enhanced Blood Texture + Immersive Sounds - Compendium
Dynamic Impact - Slash Effects X-03EBTL_ISC \ Enhanced Blood Texture Lite + Immersive Sounds - Compendium
Select only 'one' and drag and drop it into the Main folder.
5.
In the final step, inside the Main folder
Textures
Meshes
Dynamic Impact - Slash Effects X.esp
Optional esp (if you chose to use them).
Your configuration should look like the one above.
FOMOD manual installation process is over. Place the files correct paths.
3 comments